Adjustable Roller Pipe Jack Stand – 106BJS

Adjustable Roller Pipe Jack Welding Stand - BJS106

Model	Variations
108BJS	“Shortie” Adjustable Roller Stand With Rubber Rollers
109BJS	Adjustable Roller Stand With Rubber Rollers
114BJS/WSS	Adjustable Roller Stand With Stainless Steel Rollers
115BJS	Adjustable Roller Stand W/Adjustable Height

Roller Adjustment From Either End Of Carriage With 1 ¼ Hex Nuts
Rollers 5/8 x 4” Diameter Cast Iron Lathe Turned For Concentricity
Working Height 30 ¾” at Center Line of Rollers
Roller Holders Are Made Of Cast Steel
Adjusting Screw 3/4″ – 6 Pitch Full Acme Thread
Adjusting Screw Mounted in Oil Lite Bronze Bushings
Cariage Housing 2” x 3” 11 Gage Tubing
Leg Pattern 23” x 26” For Working Stability
Legs Are Of “A” Frame Design
Center Braces From Middle of Carriage To Lower Leg Brace For Even Distribution Of Load
All Legs Have 2” Diameter Foot Surface
Adjustment Of Rollers Will Accept 1/2″ – 48” Diameter Work Piece
Roller Holders Have Drain Passages To Prevent Trapped Water If Used Outdoors
Carriage Housing Has Drain Holes to Allow Water To Drain Through Legs
Legs & Braces 1” Square Tube 16 Gage
Rollers Are Powder Coated With High Visibility Safety Yellow
All Stands Are Labeled With Working Capacity Of At Least 2 to 1 Safety Factor
Certified Testing By Independent Source
Working Load Capacity 6,000 LBS
Complete Stand Weighs 32 LBS.
Stand has Powder Coat Finish

Blackjack Pipejack Stands