Adjustable Roller Pipe Jack Stand – 106BJS

Adjustable Roller Pipe Jack Welding Stand - BJS106

Adjustable Roller Pipe Jack Welding Stand - BJS106

Model Variations
108BJS “Shortie” Adjustable Roller Stand With Rubber Rollers
109BJS Adjustable Roller Stand With Rubber Rollers
114BJS/WSS Adjustable Roller Stand With Stainless Steel Rollers
115BJS Adjustable Roller Stand W/Adjustable Height
  • Roller Adjustment From Either End Of Carriage With 1 ¼ Hex Nuts
  • Rollers 5/8 x 4” Diameter Cast Iron Lathe Turned For Concentricity
  • Working Height 30 ¾” at Center Line of Rollers
  • Roller Holders Are Made Of Cast Steel
  • Adjusting Screw 3/4″ – 6 Pitch Full Acme Thread
  • Adjusting Screw Mounted in Oil Lite Bronze Bushings
  • Cariage Housing 2” x 3” 11 Gage Tubing
  • Leg Pattern 23” x 26” For Working Stability
  • Legs Are Of “A” Frame Design
  • Center Braces From Middle of Carriage To Lower Leg Brace For Even Distribution Of Load
  • All Legs Have 2” Diameter Foot Surface
  • Adjustment Of Rollers Will Accept 1/2″ – 48” Diameter Work Piece
  • Roller Holders Have Drain Passages To Prevent Trapped Water If Used Outdoors
  • Carriage Housing Has Drain Holes to Allow Water To Drain Through Legs
  • Legs & Braces 1” Square Tube 16 Gage
  • Rollers Are Powder Coated With High Visibility Safety Yellow
  • All Stands Are Labeled With Working Capacity Of At Least 2 to 1 Safety Factor
  • Certified Testing By Independent Source
  • Working Load Capacity 6,000 LBS
  • Complete Stand Weighs 32 LBS.
  • Stand has Powder Coat Finish