Adjustable Roller Pipe Jack Welding Stand with Adjustable Height - 115BJS
- Roller Adjustment From Either End Of Carriage With 1 ¼ “ Hex Nuts
- Rollers 5/8 x 4” Diameter Cast Iron
- Working Height 32 ½ “ to 43 ½ “ at Center of Roller
- Roller Holders Are Made Of Cast Steel
- Adjusting Screw 3/4″ – 6 Pitch Full Acme Thread
- Adjusting Screw Mounted in Oil Lite Bronze Bushings
- Carriage Housing 2” x 3” 11 Gage Tubing
- Leg Pattern 23” x 29” For Working Stability
- All Legs Have 2” Diameter Foot Surface
- Adjustment Of Rollers Will Accept 1/2″ – 48” Diameter Work Piece
- Roller Holders Have Drain Passages To Prevent Trapped Water If Used Outdoors
- Carriage Housing Has Drain Holes to Allow Water To Drain
- Legs & Braces 1” Square Tube 16 Gage
- Rollers Are Powder Coated With High Visibility Safety Yellow
- All Stands Are Labeled With Working Capacity Of At Least 2 to 1 Safety Factor
- Certified Testing By Independent Source
- Working Load Capacity 2,500 LBS
- Complete Stand Weighs 40 LBS
- Stand has Powder Coat Finish
